Modell inklusive elektrischem Einziehfahrwerk, Fuel-Tank und 250ml UAT, Vektor-Schubrohr und Hardware für Servos.
Die Versandkosten werden separat verrechnet, Versand über Spedition.
Specifications:
Model:
Matrix Sport Jet
Wingspan:
100.3″ (2,549mm)
Length:
110.3″ (2,802mm)
Weight:
35lbs (15.9kg) with P220 turbine without vector
FEATURES:
Extremely lightweight full composite construction especially designed for outstanding sport flight with 3D performance
Painted outside the mold so no seam lines
Ultra light weight landing gear special build for Matrix 2.8m
Specially designed easy access to turbine for speedy installation
Field setup can be done in seconds, thanks to the quick releases on the wings without the need for any tools.
the single elevator clamp from the top, only a few turns to tight/loose the bolt then you can install/take out the stabilizer.
flap can use as aileron to make very axial rolling performance with counter balance on tip aileron allow to use only 1 servo per aileron
Removable wing and stabilizer and vertical fin for easy transport
Removable two piece of fuselage for easy transport, only four bolt to lock two piece fuselage. tail pipe is fixed on the back section of fuselage. front fuselage is 1927mm, back fuselage is 875mm
The equipment installation board make the electronic items with very clear installation. Most of the wire can be hidened.
pre-install tube for the stab/rudder extension wire, easy to install.
Option with vector tail pipe for 3D flight.
Included hardware:
4in1 connector/leads for wing and fuselage
3in1 connector/leads for two piece of fuselage
2in1 connector/leads for two piece of fuselage(option for vector version)
Complete air frame (including carbon wing-tubes and preinstalled and painted fiberglass control horns)
normal tail pipe (optional Vector thrust pipe)
5.500ml fuel bag
1800ml smoke oil bag(option)
Pre-prepared pushrods with ball links
Servo connector brackets
*Also available: TR(turbine ready) version 2.8m Matrix jet with fuel bag, normal tailpipe, electric retract gear with brake, servo and hardware, preinstall the above items in factory. with wing bag.
*Also available:TR(turbine ready) PRO version 2.8m Matrix jet with fuel bag ,fuel smoke bag, smoke pump, vector tailpipe, electric retract gear with brake, servo and hardware, preinstall the above items in factory. with wing bag and fuselage bag
Required hardware:
Turbine size:
160-240N for normal sport flying
250-320N for 3D vector flight – Avoid high speed high G flying
Servos: Total x10 ( standard size )
x2 for flaps (minimum 40kg)
x1 for rudder (minimum 40kg)
x2 for ailerons (minimum 40kg)
x2 for elevators (minimum 40kg)
x1 for vector elevator (minimum 37kg), this is option
x1 for vector rudder (minimum 37kg), this is option
x1 for steering (minimum 21kg)
Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.
Control Throw in all surface
for Sport flight
Aileron: 44mm, Rudder: 50mm, Elevator: 16mm.
Flap: 74mm for take off and 108mm for landing.
for 3D flight
Aileron: 88mm up and 83mm down , Flap to Aileron is 114mm up and 108mm down Rudder: 70mm, Elevator: 20mm.
